This IR thermal camera module captures infrared radiation and converts it into a thermal image. This lets you detect heat signatures and temperature variations in the area. It has an ESP32-S3-WROOM-1 Xtensa 32-bit LX7 dual-core processor that goes up to 240MHz main frequency. It supports 2.4GHz WiFi (802.11 b/g/n) and Bluetooth 5 (LE), with an onboard antenna.

There is 16MB of flash memory, a USB-C connector for power, burning and debugging and for a project that’s on the go, there is a 3.7V MX1.25 lithium battery recharge/discharge header. There is also an app (Android Only) you can download that lets you set WiFi parameters through Bluetooth. Click here for the app setup guide

The Bluetooth app is only used for configuring parameters such as the module’s IP and device name. It does not support viewing thermal images.

Two variants are available – Basic 45 FOV or Wide Angle 90 FOV. Please select an option before adding it to your cart!

Please note: this board uses a tinyMX1.25connector for LiPo power.Most LiPo batteries on the market (including ours) use a larger JST fitting. We do not yet stock batteries with an MX1.25 connector, however, you can customise your battery withone of our 1.25mm pitch cablesto make a compatible battery yourself (assuming you have the ability, knowledge and tools to do this safely).

Features

• ESP32-S3-WROOM-1 Xtensa 32-bit LX7 dual-core processor, up to 240MHz main frequency, offering powerful data processing capabilities
• Supports 2.4GHz WiFi (802.11 b/g/n) and Bluetooth 5 (LE), with onboard antenna
• Built-in 512KB of SRAM and 384KB ROM, with onboard 8MB PSRAM and an external 16MB Flash memory
• Type-C connector, enhancing device compatibility and user convenience
• RGB LED indicator for real-time monitoring of the operating status of the module
• 3.7V MX1.25 Lithium battery recharge/discharge header for flexible power supply solution, extending device operation time
• 2 x 10 solder pads, including 14x GPIO, 1x I2C, and 1x UART, for external device expansion
• Compact size design

What’s on Board

Specifications

• Operating Voltage: 5V
• Operating Voltage: 127mA@5V
• Wavelength Range: 8~14m
• Field of View (FOV):
  • 56(D) x 45(H) x 34(V) (Basic Version)
  • 122(D) x 90(H) x 67(V) (Wide Angle Version)
• Operating Temperature: -4085
• Target Temperature: -40400
• Detection Accuracy: 2
• Refresh Rate: 25 FPS (Max)
  • Due to the influence of WiFi signals, there may be errors in the actual frame rate, subject to the usage environment.
• Dimensions: 29.0 x 29.0(mm)
• Noise Equivalent Temperature Difference (NETD): 125mK

Resources

• Product Wiki
• Thermal USB Camera PC Software
• Firmware Flashing Software

Pinout

• The module leads out the idle pins of ESP32 S3, making it easy to solder the pins themselves. If additional welding is needed, please make sure to remove the lens module first. You can use the 2×10 patch pin header with a pitch of 1.27mm.

Package Contents

Basic 45 FOV

• 1x ESP32-S3 IR Thermal Imaging Camera Module
• 1x USB Type-A to Type-C Cable ~1m
• 1x Screws Pack

Wide Angle 90 FOV

• 1x ESP32-S3 IR Thermal Imaging Camera Module
• 1x USB Type-A to Type-C Cable ~1m
• 1x Screws Pack